Adding a Dealerweb connection

To add a Dealerweb connection:

1. Click Connections in the left navigation panel.
2. Click +New Connection
3. Configure the settings in the General Settings section:

   

• Connection Enabled: Check this setting to activate the connection. Uncheck to deactivate the connection.
• Name: This is a required field for creating a connection.
• Exchange: Select FIX Order Gateway.

Note Dummy connections used for trading in ext-prod-sim must be configured using a connection with Exchange=Dealerweb (Dealerweb), instead of Exchange=FIX Order Gateway as is used for all live trading.

• In the Type field, select Dealerweb (Dealerweb).

4. Configure the settings in the Additional Settings section.

   

Configure the following Dealerweb settings per connection:

• Primary IP — Sets the exchange-provided IP address for connecting to the exchange. This is required.
• Primary Port — Sets the exchange-provided port for connecting to the exchange. This is required.
• Backup IP — (Optional) Sets the backup IP address for connecting the session if the primary IP address is not reachable.
• Backup Port — (Optional) Sets the backup port for connecting the session if the primary IP address is not reachable.
• SenderCompID — Identifies the name of the firm that sends messages to the exchange. Enter the exchange-provided ID. This field populates the value of Tag 49 (SenderCompID) in all outbound messages for the connection. This is required.
• Target Comp ID — The ID of the firm receiving messages from the exchange host. This ID is generated and provided by the exchange based on your firm name. This field populates the value of Tag 56 (TargetCompID) in all inbound messages on this connection. This is required.
• Password — (Optional) The session password provided by the exchange. This is required.
• Restrict To Markets — Set as Dealerweb.
• Max Order Rate — (Optional) Sets the maximum number of orders per second that a user can enter per connection. This limit cannot exceed the exchange-defined order rate maximum.

• Contact Email — Optionally, add a best contact email that TT can use to contact your firm if needed.

5. Click Create. You can select the connection in the data grid and review the connection settings in the Settings tab.

6. Click the Accounts tab to assign an existing account to the connection. Multiple accounts can be added to a single connection.

   Note The connection will not become active until at least one account is assigned.

7. Click Save Changes.